Produse pentru aqua assainissement (3)

Filtration process is a simple mechanical treatment applied to water for the suspended solid removal.

Protech Sil I - Therm Spatulated nanotechnological wall coating for interiors and exteriors, anti-condensation, elastomeric, sanitizing, thermal insulator, formulated with hollow glass microspheres (3M Glass Bubble), heat-reflecting based on siloxane resins in aqueous emulsion with high permeability to water vapor, with a similar final appearance to the civil plaster. It allows the creation of thermal insulation with the obvious advantages of recovering the thermal mass from the walls and eliminating bridges and thermal changes in buildings. Protech Sil I - Therm designed above all for buildings and monuments subject to the protection of the Ministry of Cultural Heritage. The binder based on an emulsion of silicones has allowed to develop a microporous filter impermeable to heavy rain, and at the same time permeable to the diffusion of water vapour. Thermal insulation coating that allows the realization of a thermal insulation with the obvious advantages of recovering the thermal mass from the walls and eliminating bridges and thermal changes of the buildings. Due to its high degree of insulation and transpiration, it is widely used to radically solve mould problems, through the synergistic action of fungicide and thermal insulation. It is composed of a water-dilutable silicone resin, acrylic dispersion, with controlled grain size marble grit, fillers, 3M Glass Bubbles, sanitizing additives and pigments, in a content that guarantees the fulfilment of physical parameters such as: permeability, water repellency, CO2 diffusion, etc. Suitable for any type of mineral support, ideal especially on walls where the growth of mould and algae represents a serious problem. Due to its low thermal conductivity, it is particularly suitable for solving problems of mould and algae on walls exposed to areas of shade and high humidity. SUPPORTS ALREADY PAINTED WITH SILOXANIC PAINT Remove any stains and proceed with painting with the siloxane coating (it is always recommended to apply a coat of siloxane impregnating agent). NEW SUPPORTS Apply a coat of siloxane acrylic fixative diluted from 20 to 60% with water depending on the absorption of the support. OLD SUPPORTS ATTACKED BY MOLDS Clean the wall from mould and algae with a steam cleaner, disinfect with Consilex Muffa Cleaner and Consilex Muffa Remover (sanitizer) after a few hours, when the microorganisms have neutralized proceed with the application of a coat of Protech Fix AC - Therm diluted from 20 to 50 % with water. Once dry, proceed with the application of Protech Sil I - Therm. The product is ready to use if necessary add a little water and stir slowly. Apply a coating layer with a stainless steel trowel with a thickness equal to that of the granules it contains. Pass again with a cutting spatula to remove any excess material. After light drying, pass over with a plastic trowel with rotary movements to compact, even out and achieve the full plaster effect. On large surfaces, it is recommended to apply the product of the same lot and proceed always wet on wet to avoid signs of resumption. Indicative consumption depending on the different particle sizes of Protech Sil I-THERM available: 1 mm GRAIN: approximately 1.6 -1.8 kg/m²; 1.2 mm GRAIN: approximately 1.8 -2.0 kg/m²; 2 mm GRAIN: approximately 2.4 -2.8 kg/m²; 2.2 mm GRAIN: approximately 2.6 -3.0 kg/m². The indicated yields refer to smooth supports and are for guidance only. Actual consumption must be identified with a suitable practical test. Pail 20 kg

Il generatore di ozono TE05 è stato creato specificamente per l’impiego su mini piscine e vasche idromassaggio. E' la soluzione ideale per il mantenimento delle condizioni igieniche ottimali nei circuiti idraulici .